Charnières d'angle amovible / filetage intérieur / zinc / GN 161.1 / GANTER
- Remise sur volume
Hinges GN 161.1 are a variant with highly attractive design. The fixing screws are invisible.
During the load tests, the hinges were gradually loaded and relieved at room temperature with incrementally increasing force.
For the specified values, an insignificant permanent deformation remained after relieving the load which had no effect on the function and appearance. In most cases, the failure loads are multiples of the specified value.
The details relating to the load bearing capacity are non-binding recommended values and rule out any liability. They constitute no general warranty of quality and condition.
The user must determine from case to case whether a product is suitable for the intended use. Environmental influences and aging may influence these values.
During the load tests, the hinges were gradually loaded and relieved at room temperature with incrementally increasing force.
For the specified values, an insignificant permanent deformation remained after relieving the load which had no effect on the function and appearance. In most cases, the failure loads are multiples of the specified value.
The details relating to the load bearing capacity are non-binding recommended values and rule out any liability. They constitute no general warranty of quality and condition.
The user must determine from case to case whether a product is suitable for the intended use. Environmental influences and aging may influence these values.
Référence pièce
Vous pouvez trouver ici le numéro
de référence lié au produit recherché.
Référence pièce
|
|---|
| 161.1-15-63-SR |
| 161.1-15-63-SW |
| Référence pièce |
Prix unitaire standard
| Quantité minimale de commande | Remise sur volume | Finish | Weight (kg) | |
|---|---|---|---|---|---|---|
10.20 € | 1 | Disponible | 7 jours | SR-silver, RAL 9006, textured finish | 0.073 | |
10.20 € | 1 | Disponible | 7 jours | SW-black, RAL 9005, textured finish | 0.072 |
Loading...
Informations de base
| Largeur l(mm) | 63 | Width b | 15 |
|---|
Configurer
Propriétés de base
-
Finish
- SW-black, RAL 9005, textured finish
- SR-silver, RAL 9006, textured finish
-
Type
- 161.1
-
Filtrer par type de données CAO
- 2D
- 3D
Filtrer par jours d'expédition standard
-
- Tous les articles
- 7 jours ou moins
Propriétés optionnelles
- Les spécifications et les dimensions de certaines pièces peuvent ne pas être intégralement indiquées. Pour plus de détails, reportez-vous aux catalogues des fabricants .
Assistance technique
Mode de paiement
Fabrication à la demande
Certificats
Copyright © MISUMI Corporation All Rights Reserved.