Filtre à gaz propre, filtre à cartouche, série SFA100/200/300 (SFA103-02)

Clean Gas Filter: Cartridge Type / Disc Type, SFA100/SFA200/SFA300 Series Specifications

SFA103 external appearance

SFA200 external appearance

SFA302 external appearance

*1: The maximum operating pressure is 0.99 MPa since this product does not conform to the High Pressure Gas Safety Law (Japan). Ensure that, if 0.1 MPa is exceeded, there is no pressure fluctuation during use.
*2: Measured under manufacturer's specified conditions.

Model

*1: At inlet pressure of 0.7 MPa and pressure drop of 0.02 MPa.
*2: Contents of diagram numbers (3) to (7) are included in the element part no. (refer to diagrams).

Product Diagram

Cartridge Type / Disc Type, SFA100/SFA200/SFA300 Series diagram

Number	Part name	Material	Note
1	Case	SUS 316	Electrolytic polishing (interior/exterior)
2	V Clamp	SUS304	-
3	Holder 1	Polyester	Element
4	Holder 2
5	Filtration Medium	PTFE
6	Packing	FKM
7	V packing

Product Outline Dimensional Drawing

SFA100-02/SFA101-02/SFA200-02/SFA201-02/SFA300-02/SFA301-02 dimensional drawings

 

(Unit: mm)

 

Model	Connection	(A)	(øB)
SFA100-02	Rc 1/4	46	76
SFA101-02	NPT 1/4
SFA200-02	Rc 1/4	51	96
SFA201-02	NPT 1/4
SFA300-02	Rc 1/4	59	120
SFA301-02	NPT 1/4

(): Reference dimensions

SFA102-02/SFA202-02/SFA302-02 dimensional drawings

 

(Unit: mm)

 

Model	Connection	(A)	(øB)
SFA102-02	TSJ 1/4 (Tube Swage Joint)	89	76
SFA202-02		93	96
SFA302-02		101	120

(): Reference dimensions

 

(Unit: mm)

 

SFA103-02/SFA203-02/SFA303-02 dimensional drawing

 

(Unit: mm)

 

Model	Connection	(A)	(øB)
SFA103-02	UOJ 1/4 (Union O-Ring Joint)	117	76
SFA203-02		122	96
SFA303-02		130	120

(): Reference dimensions

Product Flow Rate Characteristics (Fluid: Compressed Air / Inlet Temperature: 20°C)

SFA10□ flow rate characteristics

SFA20□ flow rate characteristics

SFA30□ flow rate characteristics

Precautions

• *Ensure that you read the specific product precautions prior to use.
• *Confirm the specifications. The Clean Gas Filter is designed for use with compressed air and nitrogen gas only. Do not use with fluids (gases) other than those stated in the specifications, and do not exceed the specified ranges for pressure or temperature, as this will cause damage, etc.
• *Select a product according to the maximum consumption flow rate. When using compressed air for air blow applications, etc., calculate the maximum volume of air that will be consumed before selecting the SF□ series product size. (Using a product that exceeds the maximum air flow and running excessive compressed air can cause the cleanliness of the compressed air to deteriorate and/or damage the element.)
• *Set the processing flow rate with an initial pressure drop of 0.02 MPa or less. If the initial pressure drop is set too high, the service life will be shorter due to clogging.
• *See the manufacturer's catalog for product information other than the above.
• *Product pictures are example representations for the product series. Please be aware that actual product specifications may be different.