GANTER Garnitures

?* À propos du délai d'expédition et des prix

• 

  Edge protection seal profiles

  GANTER

  GN 2182 edge protection seal profiles can be used to seal doors, covers and hatches. The profiles are pressed by hand onto the front of metal sheets and plates. The embedded clamp insert prevents detachment. Glue or other adhesives are not required.
  When assembled, the profile should deform slightly according to w2. This ensures an optimal seal. Adherance to the guideline placement radii (r1...r4) is recommended in order to ensure a tight profile seal and to make assembly easier.

  • Remise sur volume

  Fichiers CAD 2D / 3D disponibles

  à partir de∗ ：	158.20 €
  Délai d'expédition minimum ：	Jour même

  *Prix unitaire/configuration de base

• 

  Edge protection seal profiles

  GANTER

  GN 2180 edge protection seal profiles can be used to seal doors, covers and hatches. The profiles are pressed by hand onto the front of metal sheets and plates. The embedded clamp insert prevents detachment. Glue or other adhesives are not required.
  When assembled, the profile should deform slightly according to w2. This ensures an optimal seal. Adherance to the guideline placement radii (r1... r4) is recommended in order to ensure a tight profile seal and to make assembly easier.
  The NBR profiles are recommended for use in cases where contact with fuels, oils or coolants can occur.
  EPDM profiles are certified according to UL 50 and UL 94-HB and are therefore approved for the US-American and the Canadian market.

  • Remise sur volume

  Fichiers CAD 2D / 3D disponibles

  à partir de∗ ：	150.94 €
  Délai d'expédition minimum ：	5 jours

  *Prix unitaire/configuration de base

• 

  Profilés d´étanchéité et de protection d'arête

  GANTER

  • Remise sur volume

  à partir de∗ ：	8.78 €
  Délai d'expédition minimum ：	7 jours

  *Prix unitaire/configuration de base

• 

  Edge protection profiles

  GANTER

  GN 2184 edge protection profiles are installed on the front edge of metal sheets and plates. They protect the surfaces from damage by sharp edges. The edge finish additionally achieves an optical decorative effect, while the need for potential further treatment such as burring and chamfering of cut or laser-cut metal sheets is reduced to an absolute minimum.
  Adhering to the guideline placement radii (r1...r3) is recommended in order to guarantee permanent profile placement and to make assembly easier. Assembly can be carried out by hand, or alternatively with a soft-face hammer. The embedded clamp insert prevents it from detaching. Glue or other adhesive is not required.

  • Remise sur volume

  Fichiers CAD 2D / 3D disponibles

  à partir de∗ ：	88.76 €
  Délai d'expédition minimum ：	Jour même

  *Prix unitaire/configuration de base

Loading...